Zero ARF (GPMA1535)
Manual Update

PLEASE NOTE THESE CHANGES TO THE INSTRUCTION MANUAL

    On page 10 of the instruction manual, step four calls for #4 x 3/8" sheet metal screws. In this step, you should use the included #4 x 1/2" sheet metal screws.

    On page 10, when installing the landing gear plate, a notch will need to be made in the plate to allow for the clearance of the landing gear wire opposite the main strut.

    On page 10, step five calls for the use of #4 x 3/8" sheet metal screws. In this step, use a 7/64" drill to drill the locations and use the #6 x 1/2" sheet metal screws to secure the landing gear into the wing.

    On page 11, the sketch drilling the wing shows the drill entering from the bottom of the wing. This sketch is to illustrate the angle of the drill to the wing. The wing will actually be drilled from the top, while holding the drill perpendicular to the bottom of the wing.

    On page 16, steps 11 and 12 call for #4 x 1/2" sheet metal screws. In these steps, use the #4 x 3/8" sheet metal screws.

    On page 20, the step for installing the air scoop has been omitted. To install the air scoop, position it just behind the cowling on the bottom of the fuselage. The larger end will be facing forward. Use medium CA to glue the scoop into position.

We apologize for any confusion this may have caused.

Great Planes Model Manufacturing